IBM System Storage DS Architecture and Implementation. Storage facility Configuring the DS storage for FB volumes. Front cover. IBM System Storage. DS Architecture and Implementation. Bertrand Dufrasne. Andreas Baer. Peter Klee. Danijel Paulin. This IBM® Redbooks® publication describes the concepts, architecture, and implementation of the IBM System Storage™ DS series of disk storage.

Author: Yozshumi Jukora
Country: Ecuador
Language: English (Spanish)
Genre: Health and Food
Published (Last): 9 July 2014
Pages: 338
PDF File Size: 9.59 Mb
ePub File Size: 11.94 Mb
ISBN: 901-9-24314-580-9
Downloads: 41056
Price: Free* [*Free Regsitration Required]
Uploader: Akisar

It operates as a hidden partition, with no processor resources assigned to it.

Retrying the instruction will not help in this situation because the instruction will continue to fail. It means that a mini-loop sttorage created between the DA port and the disk.

The Archhitecture Sequence line shown in Figure on page 59 indicates the order in which host adapter pairs must be installed. These two servers share the load of receiving and moving data between the attached hosts and the disk arrays.

Linux is d8s000 trademark of Linus Torvalds in the United States, other countries, or both. If a cache hit occurs where requested data is already in cache, then the host does not need to wait for it to be fetched from the disks. Host adapters on the DS are available in either longwave or shortwave. This feature prevents the deletion of volumes still in use.

DS8000 architecture

Quick Initialization for open system FB volumes: Share your thoughts with other customers. A floating spare is defined as follows: The rebuild is performed by reading the corresponding data and parity in each stripe from the remaining drives in the array, performing an exclusive-OR operation to recreate the data, and then writing this data to the spare drive.


Each network attaches disk enclosures that each contain up to 24 disks.

Amazon Music Stream millions of songs. Sophisticated algorithms to determine what data needs to be stored in cache based on recent access and frequency needs of the hosts Pre-fetching, which anticipates data prior to a host request and loads it into cache Self-learning algorithms to adaptively and dynamically learn what data needs to be stored in cache based upon the frequency needs of the hosts 18 IBM System Storage DS These fans draw cooling air through the front of each disk enclosure and exhaust air out the rear of the frame.

The distance is typically limited only by the capabilities of the network and channel extension technology being used.

It also creates 5V and 12V DC power for the disk enclosures. The DS Business Class supports an optional one-phase power configuration. Figure DS switched loop layout only 8 disks per enclosure are shown for simplicity An array site consists of eight DDMs.

In each case, the FC switched networks do not need to be broken to add the disk enclosures. Again, a smart migration of the data will be performed after suitable spares have become available.

In a full four frame installation, the drives are distributed over all the device adapter DA pairs. The third expansion frame is identical to the second expansion frame.

IBM System Storage DS Architecture and Implementation Front cover

It is possible that your sequential throughput requirements will be high, but your capacity requirements are low. The left side of each expansion frame, viewed from the front of the machine, is the frame power area.


One disk enclosure of the pair is on one FC switched loop, and the other disk enclosure of the pair is on a second switched loop. Mutual surveillance The SP archigecture monitor the operation of the firmware during the boot process, and it can monitor the operating system for loss of control. The intention is to only have four spares per DA pair. Such trademarks may also be registered or common law trademarks in other countries.

IBM System Storage DS8000: Architecture and Implementation

DS Model standard cabling: A processor complex is also referred to as a storage server or central electronics complex. HA cards can be installed in slot 1 and 4 only. The data has now moved to a slower DDM and is wasting a lot of space.

On the DS, the following three disk technologies are supported: Thus, when a systeem fails in one of the RAID 0 arrays, we can rebuild the failed drive by reading the data from the equivalent drive in the other RAID 0 array. The base frame can contain up to eight disk enclosures installed in pairseach of which can contain up to 16 disk drives.

Although functionally the DS and DS are similar, many of their hardware components are different. These enterprise class drives, using a 2.